Suzuki SMD16 User Manual

5. POINTS, EVENT MARKS
5-16
5.13.3 How to go to a point selected from the points list
1. Open the home screen, then tap [Lists].
2. Tap [Points] to open the points list.
3. Tap [Name], [Icon], [Color] or [Range] at the top of the list to sort the list.
4. Tap the point to go to, then tap [Goto].
5. Tap the close button to close the points list.
The following occurs:
• The go to point is highlighted.
• A thick red dashed line and a yellow line appear. The thick red dashed line is the
course to follow to get to the point. The yellow line is the shortest course from the
current position to the go to point.
• The arrival area marker appears if activated on the menu (see paragraph 6.11.5).
• The XTE lines, red for port side, green for starboard side, appear. You can show or
hide these lines with [Display XTE Lines] in the [Settings] - [Routes] menu.
Note: If you want to be notified when you reach the go to point (the end of a route),
turn on [End of Route Notification] in the [Routes] menu (see paragraph 6.11.9). Then
the message "End of Route" appears when you reach the end of a route. For the ar-
rival timing, see paragraph 6.11.5.
5.13.4 How to use the NAVpilot to steer to a point
When you select a point to follow and the NAVpilot is engaged and activated in the
system, the message "DO YOU WANT TO NAVIGATE USING THE NAVPILOT?" ap-
pears. Tap [Yes] to have the NAVpilot steer the vessel, then the NAVpilot automati-
cally goes into the Nav mode.
Note: The example figure below shows the NAVpilot-300 series. The turn/menu but-
ton is not shown on the NAVpilot-700 series, however all other indications are the
same.
Use the course adjustment buttons to set the course to steer. Tap the double arrow
for coarse adjustment, and single arrow for adjustment in 1° steps.
To go to the stand-by mode, tap the NAVpilot control box.
AUTO modeAUTO mode Stand-by modeStand-by mode NAV modeNAV mode
Course adjustment buttons.
(Port=Red, STBD=Green)
Tap the single arrow for fine adjustments;
Tap the double arrow for coards adjustments.
Turn/Menu button.
Appears in all modes for
NAVpilot-300 series only.
AUTO/NAV
mode buttons.

Suzuki SMD16 Specifications

General

Brand	Suzuki
Model	SMD16
Category	Monitor
Language	English