Synesso MVP Technical Manual

13
HYDRA PACKAGE REQUIREMENTS & INSTALLATION
MVP Hydra Installaon Requirements:
Electrical:
The Hydra package has a slightly greater amp draw than the single pump machines; please note the max
amp draws and plan your electrical installaon accordingly. See table on page 12.
Each pump motor has a disnct color associaon, which is indicated throughout the machine by colored
wires and zip es. The colors are as follows:
 Group 1: Grey
 Group 2: Purple
 Group 3: Brown
 Water inlet for the steam tank: Pink
Wherever these colors are seen, it is crical for proper machine funcon that they are matched up correct-
ly (grey to grey, etc.) for both electrical and plumbing systems.
Plumbing:
Hydra packages require one incoming water source like single pump machines. The water passes through a
manifold (commonly part of the line pressure regulator) and is distributed to each pump. Once again, fol-
low the color coding for proper installaon of the hoses from the output of each pump to the machine.
Pressure Regulator Plumbing & Bypass Box Wiring:
Pump cord installaon: Insert the color coded pump cable into the opening of the matching bypass box and
aach the wires to the terminal as shown in the picture above: green wires stacked on the ground bolt, white
to white/red, black to black/blue, connect the bullet connectors.
Pressure regulator: Used to achieve the stage 1 low pressure pre-infusion. It is set and tested at 50 psi in the
Synesso™factory. This pressure seng can be lowered if desired, but 50psi is the maximum output pressure.
To adjust the pressure regulator, rst loosen the nut on the threaded post, then turn the post counter-
clockwise to decrease pressure.
Pressure Regulator
Bypass Box
Pink

Synesso MVP Specifications

General

Brand	Synesso
Model	MVP
Category	Coffee Maker
Language	English