93
OPERATION
Handling in Cold Weather
Cautions after Completing
Operations
Heed the following in order to prevent dirt,
water, or other objects stuck on the machine
as well as the undercarriage from freezing:
�
Remove any dirt or water from the body.
In particular, water droplets on the hydraulic
cylinder rod surfaces could freeze, and if
dirt enters into the seals along with this,
the seals could break.
�
Park the machine on a dry, hard surface.
If no appropriate place can be found, put
boards down and park the machine on
them.
�
Drain any water from the fuel tank to
prevent freezing.
Refer to page 129 “Draining the Fuel
Tank”.
�
To prevent decreased battery performance,
place a cover over the battery or remove
it from the machine and store it in a warm
place.
Also add battery fluid before starting the
next morning. If battery fluid is added after
completing operations, the distilled water
may not mix, resulting in freezing.
After Cold Weather is Over
Perform the following after cold weather is
over:
�
Change the fuel and the oils for the different
devices with those specified on the Fuel
and Lubricant Chart.
Refer to page 106 “Fuel and Lubricant
Chart”.
�
When using one-season type antifreeze
coolant, completely drain the antifreeze
coolant, carefully clean the inside of the
coolant system, then add tap water.
Refer to page 137 “Cleaning the Engine
Cooling System”.
Preparing for Cold Weather
In cold weather, it may be difficult to start the
engine and the coolant may freeze. Make the
preparations described below.
Changing the Fuel and Lubricant
Change the fuel, hydraulic oil and engine oil
to types suited for cold conditions.
Refer to page 106 “Fuel and Lubricant
Chart”.
Engine Coolant
WARNING
The coolant is combustible. Keep flames
away.
Use long-life coolant (antifreeze) and tap
water for the engine coolant.
Supplement: New machines are delivered
with JIS Type 2 long-life coolant (antifreeze)
at a concentration of 50%.
Refer to page 106 “Fuel and Lubricant
Chart”.
Battery
As the temperature drops, the battery
performance decreases.
Inspect the battery. If the charge is low,
contact a Takeuchi sales or service outlet to
have the battery charged.
Refer to page 128 “Inspecting the Battery
Fluid Level and Replenishing”.