TBB Energier Apollo CH3.0S User Manual

Energier Apollo User Manual
46
Energier Apollo is equipped with two programmable relay that are set by default as a battery low
alarm relay. However the relay can be programmed for all kinds of other applications.
6.7 How to program trigger source of dry output contact
Refer to 6.7, set for AGS function setting please use Rapconfig “AGS” generator condition.
For example as a starter relay for a generator, user can set programmable relay as AGS on Rapconfig
software with PC.
6.8 How to get AGS function
For restore factory setting, please refer to chapter 5.4.6 system control.
6.9 How to restore factory setting
Page
Auxiliary out1
Battery Low
Battery Low
General
Advanced
Enter
ESC
down x 8
Page up
Rated voltage
230V
Page down
Page up
Auxiliary out2
Settable optional:
Battery low
Overload
Over temperature
Output short
Over charge
Inverter fault
Fan running
AGS

TBB Energier Apollo CH3.0S Specifications

General

Brand	TBB
Model	Energier Apollo CH3.0S
Category	Inverter
Language	English