Energier Apollo User Manual
Thanks for choosing TBB products and this manual is suitable for Energier Apollo. This chapter
contains important safety and operation instructions. Read and keep this User Manual well for later
reference.
The Energier Apollo needs to be installed by professionals and please pay attention to the following
points prior to installation:
1)
Please check the input voltage or battery voltage is same as the nominal input voltage of the
inverter.
2)
Please connect positive terminal “+” of battery to “+” input of the inverter.
3)
Please connect negative terminal “-” of battery to “-” input of the inverter.
4)
Please connect positive terminal “+” of photovoltaic panel to “PV+” input of the inverter.
5)
Please connect negative terminal “-” of photovoltaic panel to “PV-” input of the inverter.
6)
Please use the shortest cable to connect and ensure the secure connection.
7)
While connecting, please secure the connection and avoid short cut between positive terminal
and negative terminal of battery, which will cause damage to battery.
8)
Inverter will have high voltage inside. Only authorized electrician can open the case.
9)
The inverter is not designed to use in any life retaining equipment. There should be safe backup
measures to ensure that the failure of the power supply does not affect the continuous operation
of life first aid or maintenance devices.
1. Safety instructions
1.1 General
WARNING: ELECTRICAL SHOCK HAZARD
1
As dangerous voltages and high temperature exist within the Energier Apollo, only
qualified and authorized maintenance personnel are permitted to open and repair it.
There are dangerous voltage existed on the input or output terminals, even when
Energier Apollo has been switched off.
To Next Page
Loading...
Need help?
General
