95
(Continued)
Download Fail
• The firmware download has failed. Press any
button to exit. Please try again later.
• The server cannot be found. Press any button to
exit. Make sure that the network is connected to
the internet.
Empty
• The selected folder is empty. Move tracks into the
folder and retry the operation.
• The server is not found on the network. Check to
see if the server is connected to the same network
as this unit, and retry the connection to this unit.
(⇒ 26)
• No Internet Radio station is registered to the
favourite list. Add a station to the list. (⇒ 62)
Error
• Incorrect operation is performed. Read the
instructions and try again.
Fail
• Network connection is not complete. Try the
setting again. (⇒ 26)
Firmware update is available
• The firmware (free of charge) for this unit is
available.
Press [OK].
Press [ ], [ ] to select “Yes” and then press
[OK].
• The progress is displayed as “Updating
%”
while updating. (“ ” stands for a number.)
• Do not disconnect the AC mains lead or turn
this unit to standby while updating. (⇒ 83)
• When the update has finished successfully,
“Success” is displayed.
Disconnect the AC mains lead and reconnect it
after 3 minutes.
• For the update information, refer to the following
website.
www.technics.com/support/firmware/
“F
” (“ ” stands for a number.)
• An abnormality has occurred. (If this unit detects
an abnormality, the protection circuit is activated,
and the power may be turned off automatically.)
Is this unit placed in an extremely hot place?
Wait a few seconds and then turn the unit
on again. (The protection circuit will be
deactivated.)
If the problem persists, write down the displayed
number, disconnect the AC mains lead and consult
your dealer.
Load Fail
• The firmware cannot be found on the USB flash
memory.
• Download the latest firmware on the USB flash
memory and try again. (⇒ 84)
To Next Page
Loading...
Need help?
General
