Tektronix 466 User Manual

BASIC OSCILLOSCOPE
DISPLAYS
These instructions permit the operator to obtain the
most commonly used basic displays .
NORMAL SWEEP DISPLAY
1. Set the controls as follows :
VERT MODE
VOLTS / DIV
VOL TS/ DIV VAR
AC-GND-DC
Vertical POSITION
20 MHz BW
INVERT
Vertical
CH 1
Positi on determined by
amplitude of signal to
be applied
Calibrated detent
AC
Midrange
Not limited (yellow band
not visible)
Button out
Horizontal
TIME / DIV Switches Locked together at 1 ms
A TIME /DIV VAR Calibrated detent
HORIZ DISPLAY A
X10
MAG
POSITION
Off (button out)
Midrange
THE ADJUSTABLE CARRYING HANDLE IS DESIGNED
TO OFFER CONVENIENT, STABLE OPERATING PO-
SITIONS . THE NEXT-TO-LAST LOCKING POSITION OF THE
HANDLE PROVIDES THE MOST STABLE , NEAR-UPRIGHT,
OPERATING POSITION. 1737 · 15
Fig. 9. Tilted operation.
18
466/464 DM44 Operators
@

Tektronix 466 Specifications

General

Brand	Tektronix
Model	466
Category	Test Equipment
Language	English