Tektronix 466 User Manual

J
J
]
J
J
The readout should be -2° C to 2° C. There should be
ice remaining after the test to verify that inserting the
probe did not raise the water temperature.
High Temperature
Bring water to a slow boil (to prevent splattering). Put
the probe tip into the water, avoiding the side or bottom of
the container. Wait for the readout to stabilize, indicating
the probe has reached the water temperature.
The readout should be between
98°C and 102°C for
clean water at sea level.
TIME AND 1/TIME
See DM44 DELAYED OR MIXED SWEEP
MEASUREMENTS in this manual.
@
466/464 DM44 Operators
31

Tektronix 466 Specifications

General

Brand	Tektronix
Model	466
Category	Test Equipment
Language	English