Tektronix 466 User Manual

]
J
J
]
l
J
l
l
To find the pulse repetition rate, superimpose the
waveforms as above and set the FUNCTION switch to
1/TIME. The Readout and Scale Factor Lamps now
indicate the repetition rate.
TIME DURATION MEASUREMENTS
(DM44)
Set controls as follows:
FUNCTION
HORIZ DISPLAY
B
SOURCE
A TIME/DIV
B TIME/DIV
!),. TIME
VAR TIME/DIV
TIME
AINTEN
STARTS AFTER DELAY
To display a single
event.
3
or 4 positions more
cw than A TIME/DIV
To move the time-
measurement point to
the right of the ref-
erence point.
Detent
position
Use the DELAY TIME POSITION control to move the
reference
point to a horizontal graticule line (see Fig. 32A,
Point A}. Use the !),. TIME control to move the time-
measurement point to near the same horizontal graticule
line on the next cycle of the waveform (see Fig. 32A, Point
B}.
(A) A SWEEP DISPLAY
L
SUPERIMPOSE
PORTIONS OF
WAVEFORM
(B) B DLY'D DISPLAY
2039-31
Fig. 32. Time duration and frequency measurements.
@
466/464 DM44 Operators
61

Tektronix 466 Specifications

General

Brand	Tektronix
Model	466
Category	Test Equipment
Language	English