Removal and Installation Procedures
6-22 AFG3000 Series Arbitrary/Function Generators Service Manual
Generator Board
You will need a torque-limiting Torx T-15 screwdriver.
Removal. To remove the Generator board, refer to Figure 6-18 and follow these
steps:
1. Remove the six screws attaching the Generator board to main chassis.
2. Remove the two screws attaching the Generator board to main chassis from the
bottom side.
3. Remove the Generator board from the main chassis.
Figure 6-18: Generator board removal
Installation. To install, reverse this procedure.
To Next Page
Loading...
Need help?
General
