In this section:
Introduction .............................................................................. 2-1
2601B-PULSE weights and dimensions ................................... 2-1
Installing the 2601B-P-INT ....................................................... 2-6
Cooling vents ........................................................................... 2-8
Turning the instrument on and off ............................................ 2-9
Placing a 2601B-PULSE in standby ....................................... 2-11
Warmup period ....................................................................... 2-11
Line frequency configuration .................................................. 2-11
Remote communications interfaces ....................................... 2-12
Using the interlock .................................................................. 2-37
System information ................................................................ 2-41
Introduction
This section provides the information you need to install the 2601B-PULSE, make communications
connections, and power up the instrument.
2601B-PULSE weights and dimensions
The instrument weighs 5.9 kg (13 lb) without the 2601B-P-INT attached. With the 2601B-P-INT
attached, it weighs 6.4 kg (14 lb).
The following figure shows the mounting screw locations and dimensions. The dimensions shown are
typical for both sides of the instrument.
For front mounting, use #8-32 × 3/8 in. Phillips pan-head screws. For rear mounting, use
#10-32 × 3/8 in. Phillips pan-head SEMS screws.
To Next Page
Loading...
Need help?
General
