Preparing the instrument for rack mounting
To remove the handle, mounting ears, and rear feet:
1. Gently pull the handle (1) away from the sides of the instrument case and swing it up or down
until the orientation arrows on the handles line up with the orientation arrows on the two mounting
ears, as shown in the following figure.
Figure 6: Rack-mount kit handle removal
2. After you align the arrows (2), pull the ends of the handle (1) away from the case.
3. Remove the screws that secure the two mounting ears (3).
4. Pull down and out to remove each ear.
Figure 7: Mounting ear removal
5. From the bottom of the instrument, pull out the two rubber feet and remove the two screws (4).
For the locations, see the following figure.
Figure 8: Instrument rubber feet removal
Store the handle, rubber feet, and hardware for future use.
To Next Page
Loading...
Need help?
General
