In this section:
Introduction .............................................................................. 2-1
Locating the system ................................................................. 2-2
Basic system connections ........................................................ 2-3
GPIB connections .................................................................... 2-8
Preamplifier mounting .............................................................. 2-9
Connections to the device under test ..................................... 2-11
Powering the 4200A-SCS ...................................................... 2-12
Powering off the 4200A-SCS ................................................. 2-13
Configuring the system .......................................................... 2-14
Introduction
This section contains information about handling and installing the 4200A-SCS:
• Locating the system: Describes how to select the best operating environment location for your
4200A-SCS.
• Basic system connections: Explains how to connect the grounding cable, LAN cable,
GPIB-compatible instruments, and the safety interlock to the 4200A-SCS.
• GPIB connections: Describes recommended cables and configuring controller and subordinate
operation.
• Preamplifier mounting: Describes how to mount preamplifiers remotely or on the rear panel.
• Powering the 4200A-SCS: Describes line power requirements for the 4200A-SCS and shows
how to connect the power-line cord.
When you start one of the Clarius
+
applications for the first time, you must agree to the
license agreement before continuing. If you do not respond with "Yes", your system will not
function until you reinstall the software.
To Next Page
Loading...
Need help?
General
