5. T
ap the Mode field and select the measurement type you want to take: DC, AC RMS, AC+DC RMS, or Frequency.
6. Tap Show Basic Statistics in Badge to display statistics in the measurement badge.
7. Tap an empty location on the display to close the DVM menu.
View the finished results in the DVM results badge.
Taking manual measurements with cursors
Cursors are on-screen markers that you position in the waveform display to take manual measurements on acquired data.
To take manual measurements with cursors in the frequency domain, see Frequency domain cursors on page 245.
Cursors appear as horizontal and/or vertical lines. To use cursors on analog or digital channels:
1. Tap the Cursors on-screen button or push the Cursors front-panel button.
Note: A second tap or push turns cursors of
f.
As you turn Multipurpose a, you move one cursor to the right or left. As you turn Multipurpose b, you move the other cursor.
2. Double-tap a cursor to display the cursor menu.
3. Tap Cursor Mode. Selecting Independent allows the a and b cursors to move independently.
Selecting Linked turns the cursor linking on. If linking is on, turning Multipurpose knob a moves the two cursors together. Turning
Multipurpose knob b adjusts the time between the cursors.
4. Push a Multipurpose knob to toggle between a coarse and a fine adjustment for the Multipurpose knobs.
5. Double-tap a cursor to display the cursor menu.
6. Tap Cursor Type and select Screen from the list.
In Screen mode, two horizontal bars and two vertical bars span the graticule.
7. Tap a horizontal cursor. Turn Multipurpose a and Multipurpose b to move the pair of horizontal cursors.
Measurement concepts
3 Series Mixed Domain Oscilloscope Printable Help 258
To Next Page
Loading...
Need help?
General
