Configure the instrument
Set the date and time
Set the date and time so that saved files are marked with the correct date and time information.
Procedure
1. Double-tap the Date/T
ime badge (bottom-right of screen) to open the configuration menu.
2. T
o turn off showing the date and time on the screen, tap the Display button to Off.
To turn on date/time display again, double-tap in the blank area where the date/time badge was displayed to open the configuration
menu and set the Display button to On.
3. You may also tap the Year, Day, Hour, Minute, or UTC Offset fields and use the multipurpose knobs to set the fields to the correct
time.
You may also double-tap the fields and use the numeric keypad to set the time.
4. Tap Month and select the month from the list.
5. Tap anywhere outside of the menu to close it.
Functional check
Use this procedure to quickly verify that the oscilloscope can display a waveform and take a measurement.
Procedure
1. Power on the oscilloscope.
2. Tap Utility > Self test. Check that all tests listed show Pass.
3. Connect an analog probe to the Channel 1 connector.
4. Connect the probe tip and ground lead to the probe compensation connectors.
5. Push the Autoset button. You should see a square wave in the display (approximately 2.5 V
P-P
).
6. Tap the Measure button.
7. Tap the Time Measurements panel in the Add Measurements configuration menu.
8. Double-tap the Frequency button and then the Add button to add the frequency measurement to the Results bar.
Configure the instrument
3 Series Mixed Domain Oscilloscope Printable Help 58
To Next Page
Loading...
Need help?
General
