Before you begin
T
o set measurement gates you must be taking a measurement. See Add a measurement on page 72.
Procedure
1. Double-tap a measurement badge to open the Measurement configuration menu.
2. Tap the Global Measurement Settings panel.
3. Tap Gating and either Off, Screen, or Cursors gating:
• Off takes measurement across the entire waveform record.
• Screen takes measurements on that portion of the waveform shown in the display. When Zoom is on, the display is the zoom
window.
• Cursors takes measurements on that portion of the waveform between the cursors. Selecting Cursors opens cursors on the
measurement source. Set the cursors so that the waveform area of interest is between the cursors.
4. Tap anywhere outside the Measurement configuration menu to close it.
Customizing measurements
3 Series Mixed Domain Oscilloscope Printable Help 95
To Next Page
Loading...
Need help?
General
