GPS7 GPS Synchronization and Timecode module remote commands
:STATE
0|1
:OUTput
POS_V | NEG_V | OFF
:LOOP
0|1
:LOOP?
Command d escription
:OUTPut1:STATe 0 | 1
NOTE. This command is not supported by G PS7 modules that do not have a REF
IN connector.
Sets the Black1 output. Select 1 to enable the Black1 output. Select 0 to
disable the Black1 output.
:OUTPut1:STATe?
Returns the Black1 output state.
:OUTPut[1/2/3]:STANdard
NTSC|PAL|NTSC_NSU|HD1080_ 60I|HD1080_59I| HD1080_50I|
HD1080_24SF|HD1080_23SF|H D1080_30P|HD1080_29P|
HD1080_25P|HD1080_24P| HD108 0_23P|HD720_60P|HD720_59P|
HD720P_50P|CW_10MHZ
Sets the video standard for the serial digital black signals output from the
BLACK connectors. This command is only available if Option BK is installed.
:OUTPut[1/2/3]:STANdard?
Returns the video standard for the serial digital b lack signals output from
the BLACK connectors. This command is only available if Option BK is
installed.
:OUTPut[1/2/3]:SIGNal BB | BB_FREF | BB_ NO_REF
Sets the Black Output signal. The selections are BB: Black burst; BB_FREF:
Black burst with field reference; and BB_NO_REF: Black b urst with no field
reference.
I
f the output standard (OUTPut<1/2/3>:STANDard) is set for HD rates or
CW_10MHZ (Black 3 only), the command returns an ERROR.
If the output standard is set to PAL, then the BB and BB_FREF settings output
a black burst signal with field reference. The BB_NO_REF setting outputs a
black burst signal with no field reference.
If the output standard is set to NTSC or NTSC_NSU, then the BB_FREF
setting outputs a black burst signal with field reference. The BB and
BB_NO_REF settings output a black burst signal with no field reference.
:OUTPut[1/2/3]:TIMECode:S OURce DISable|TOD|COUNter
Draft
92 TG8000 Multiformat Test Signal Generator Programmer Manual
To Next Page
Loading...
Need help?
General
