BG7 Black Generator module remote commands
BG7 Black Gene
rator module remote commands
This section
describes the command sets used for the BG7 Black Generator
module remote operation. The commands for the module are divided into the
following groups:
OUTPUT commands
SENSE comm
ands
OUTPUT commands
Use these
commands to set the video standard and the kind of signal for the
BLACK outputs.
NOTE. Use of the OUTPUT4:TIMEcode commands requires hardware version
1.2 or later and s oftware version 5.1 or later.
Command tree
:OUTPut
:CONFigure
:OUTP
ut<n>
:STANdard NTSC | NTSC_NSU | PAL |
HD1080_60I | HD1080_59I |
HD1080_50I | HD1080_24SF |
HD1080_23SF | HD1080_30P
| HD10 80_29P | HD1080_25P
| HD10 80_24P | HD1080_23P
| HD720_60P | HD720_59P |
HD720_50P
:OUTPUT4
:TIMECode
:S
TATus
:SOURce
DISable | TOD | COUNter
:SOURce
:OFFSet
<NR1>,<NR1>,<NR1>,< NR1>
:OFFSet
:VITc[1/2]
:STATe <BOOLEAN>
:STATe
:LINe
<NR1>
:LINe
:DROPf
Draft
60 TG8000 Multiformat Test Signal Generator Programmer Manual
To Next Page
Loading...
Need help?
General
