Tektronix TG8000 Programmer's Manual

TG8000 remote commands
No Alarm
Genlock: Near Loss of Lock
Genlock: Loss of Lock
No Signal
Fan Fault
:SYSTem:BEEPer <boolean>
Enables/d
isables the front panel beeper alarm.
:SYSTem:ERRor?
Lists the next event in the Error/Event queue. Queue is cleared at power up,
upon *CLS, and upon reading the last item.
:SYSTem:HELP:SYNTax?
Lists correct command syntax.
:SYSTem:KLOCk:STATe ON|OFF
Locks or unlocks the front-panel buttons. You can use 1 or 0 instead of ON
or OFF.
:SYSTem:KLOCk:STATe?
Retu
rns the current status of the front-panel buttons.
:SYSTem:RESTart[:NORMal]
Restarts the instrument application into normal mode. This is the same
as holding the MODULE, FORMAT and ENABLE buttons to restart the
in
strument.
:SYSTem:RESTart:FACTory
Restarts the instrument into factory mode.
:SYSTem:UPGRade
Initiates n etwork firmware upgrade process.
:SYSTem:USB:MOUNt
Mounts a flash drive attached to the front-panel USB port.
:SYSTem:USB[:STATe]?
Returns the current state of any flash drive connected to the front-panel USB
port. Possible return values are:
Draft
TG8000 Multiformat Test Signal Generator Programmer Manual 27

Tektronix TG8000 Specifications

General

Brand	Tektronix
Model	TG8000
Category	Portable Generator
Language	English