Specifications
Table 14: Progr
am error alarms
Characteristic Performance requirement Reference information
Alarm Coverage
Alarms only re
ported on selected input.
(See Table 45 on page 30.)
Alarm Log Dep
th
10,000 alarm
entries.
Volatile
Alarm Log Time stamping
Time of Day,
and Selectable LTC, VITC,
or ATC ( Ancillary Time Code).
Alarm Notification All alarms may be configured to be
reported to any or all of the following:
XGA displa
y Icon or Text, Beeper, SNMP,
Ground Closure Alarm Output, Web
based User Interface, Alarm Log.
Table 15: Ethernet
Characteristic Performance requirement Reference information
SNMP For instrument control & feedback of
status. Complies with SNMP v ersion 2.
IP Address Mode
Supports manual and DHCP.
Connector RJ-45 LAN connector supporting 10/100
BaseT.
The 10/100Base-T Ethernet port
connector arrangements:The RJ-45
connector has built in LEDs. The Green
LED indicates an active connection. The
Yellow LED indicates speed. ON = 100,
OFF = 10.
Tabl
e 16: XGA picture monitor output characteristics
Characteristic Performance requirement Reference information
Amp
litude, typical
Can switch between 1 V and 0.7 V.
Res
olution
102
4 x 768 with 16 colors.
Table 17: Ground closure remote / LTC time code input characteristics
Characteristic Performance requirement Reference information
LTC Input Connector
Balanced, unterminated
through rear panel GC remote
connector.
LTC Input Impedance Greater than 10 kΩ .
LTC Signal Characteristics Linear Time Code per IEC
Publication 461.
LTC Signal Amplitude Range,
typical
0.2 V
p-p
to 5.0 V
p-p
balanced
differential or single-ended.
Waveform Rasterizers Specifications and Performance Verification 9
To Next Page
Loading...
Need help?
General
