Field Description
Remote IP Address Enter the fixed IP address of the LNS used as the destination
address for connections based on this profile.
The destination must be a device that can behave like an LNS.
UDP Source Port Enter how the port number to be used as the source port for all
outgoing L2TP connections based on this profile is to be de-
termined.
By default, the Fixed option is disabled, which means that ports
are dynamically assigned to the connections that use this pro-
file.
If you want to enter a fixed port, enable the 9< option. Se-
lect this option if you encounter problems with the firewall or
NAT.
The available values are to $.
UDP Destination Port Enter the destination port number to be used for all calls based
on this profile. The remote LNS that receives the call must mon-
itor this port on L2TP connections.
Possible values are to $.
The default value is + (RFC 2661).
The menu Advanced Settings consists of the following fields:
Fields in the Advanced Settings menu.
Field Description
Local IP Address Enter the IP address to be used as the source address for all
L2TP connections based on this profile.
If this field is left empty, your device uses the IP address of the
interface used to reach the remote IP Address by the L2TP tun-
nel.
Hello Intervall Enter the interval (in seconds) between the sending of two L2TP
HELLO messages. These messages are used to keep the tun-
nel open.
The available values are to , the default value is $. The
Teldat GmbH
18 VPN
bintec Rxxx2/RTxxx2 363
To Next Page
Loading...
Need help?
General
