Field Description
DSCP/TOS Filter
(Layer 3)
Select the Type of Service (TOS).
Possible values:
•   (default value): The type of service is ignored.
• .*2 =& 6,3: Differentiated Services Code Point
according to RFC 3260 is used to signal the priority of IP
packets (indicated in binary format, 6 bit).
• .*2 .", 6,3: Differentiated Services Code Point
according to RFC 3260 is used to signal the priority of IP
packets (indicated in decimal format).
• .*2 ?<", 6,3: Differentiated Services Code
Point according to RFC 3260 is used to signal the priority of
IP packets (indicated in hexadecimal format).
• (:* =& 6,3: The TOS value is specified in binary
format, e.g. 00111111.
• (:* .", 6,3: The TOS value is specified in decimal
format, e.g. 63.
• (:* ?<", 6,3: The TOS value is specified in
hexadecimal format, e.g. 3F.
COS Filter
(802.1p/Layer 2)
Enter the service class of the IP packets (Class of Service,
CoS).
Possible values are whole numbers between  and +. Value
range  to +.
The default value is .
14.4.2 QoS Classification
The data traffic is classified in the Networking->QoS->QoS Classification menu, i.e. the
data traffic is associated using class IDs of various classes. To do this, create class plans
for classifying IP packets based on pre-defined IP filters. Each class plan is associated to
at least one interface via its first filter.
14.4.2.1 New
Choose the New button to create additional data classes.
14 Networking Teldat GmbH
216 bintec Rxxx2/RTxxx2
To Next Page
Loading...
Need help?
General
