Field Description
• .*2 .", 6,3: Differentiated Services Code Point
according to RFC 3260 is used to signal the priority of IP
packets (indicated in decimal format).
• .*2 ?<", 6,3: Differentiated Services Code
Point according to RFC 3260 is used to signal the priority of
IP packets (indicated in hexadecimal format).
• (:* =& 6,3: The TOS value is specified in binary
format, e.g. 00111111.
• (:* .", 6,3: The TOS value is specified in decimal
format, e.g. 63.
• (:* ?<", 6,3: The TOS value is specified in
hexadecimal format, e.g. 3F.
Set COS value
(802.1p/Layer 2)
Here you can set/change the service class (Layer 2 priority) in
the VLAN Ethernet header of the IP packets, based on the class
(Class ID) that has been defined.
Possible values are whole numbers between  and +.
The default value is #.
Interfaces Only for Class map = '1
When creating a new class plan, select the interfaces to which
you want to link the class plan. A class plan can be assigned to
multiple interfaces.
14.4.3 QoS Interfaces/Policies
In the Networking->QoS->QoS Interfaces/Policies menu, you set prioritisation of data.
Note
Data can only be prioritized in the outgoing direction.
Packets in the high-priority class always take priority over data with class IDs 1 - 254.
It is possible to assign or guarantee each queue and thus each data class a certain part of
the total bandwidth of the interface. In addition, you can optimise the transmission of voice
data (real time data).
Teldat GmbH
14 Networking
bintec Rxxx2/RTxxx2 219
To Next Page
Loading...
Need help?
General
