Fields in the Basic Parameters menu.
Field Description
Rule Chain
Select whether to create a new rule chain or to edit an existing
one.
Possible values:
• '1 (default value): You can create a new rule chain with this
setting.
• A' ! ",## ),B: Select an already existing rule
chain, and thus add another rule to it.
Description Enter the name of the rule chain.
Access Filter
Select an IP filter.
If the rule chain is new, select the filter to be set at the first point
of the rule chain.
If the rule chain already exists, select the filter to be attached to
the rule chain.
Action
Define the action to be taken for a filtered data packet.
Possible values:
• -,,1 (default value): Allow packet if it matches the filter.
• -,,1 ! !, #  ": Allow packet if it
does not match the filter.
• .& ! !, "#: Deny packet if it matches the
filter.
• .& ! !, #  ": Deny packet if it does
not match the filter.
•  : Use next rule.
To set the rules of a rule chain in a different order select the button in the list menu for
the entry to be shifted. A dialog box opens, in which you can decide under Move whether
the entry ,1 (default value) or  another rule of this rule chain is to be shifted.
14.5.3 Interface Assignment
In this menu, the configured rule chains are assigned to the individual interfaces and the
gateway’s behavior is defined for denying IP packets.
Teldat GmbH
14 Networking
bintec Rxxx2/RTxxx2 233
To Next Page
Loading...
Need help?
General
