APPENDIX B
Appendix B Terex South Dakota, Inc. B-1
APPENDIX - B
APPENDIX - B
RESPONSIBILITIES
ANSI A10.31-2013 (PARTIAL)
Table of Contents:
7. RESPONSIBILITIES OF DEALERS AND INSTALLERS
7.1 General Responsibilities. Each dealer or installer as applicable shall comply with the requirements of
this section.
7.2 Vehicle Specifications. Each dealer or installer, or both, who sells a digger derrick shall inform the
owner or user, or both, of the manufacturer’s minimum vehicle specifications.
7.3 Vehicle Weight Distribution. The installer shall be responsible for the weight distribution of the
completed mobile unit in accordance with the requirements of the digger derrick and the applicable
regulations. Allowance shall be made for the weight of readily removable tools and material specified by the
user.
7.4 Manuals. Upon delivery of the equipment to the owner or user, the dealer or installer shall provide the
manuals as required by Section 6.4 and manuals for auxiliary equipment added by the installer.
7.5 Installations. The installer shall comply with Sections 5 and 6 relating to proper installation and shall
follow the instructions of the manufacturer. In the event the original manufacturer no longer exists, an
equivalent entity may provide these instructions. The installer of a digger derrick shall meet the following
requirements before the mobile unit is placed in operation:
(1) Complete successful stability tests in accordance with the requirements of 4.5.1, 4.5.2 and
4.5.3.
(2) Complete operational and visual tests in accordance with the requirements of 6.6.1 and 6.6.2.
(3) Complete appropriate electrical tests required in 5.4. For insulating digger derricks, the installer
shall assure conformance to the qualification test requirements of 5.3.2, either by obtaining
certification of the test and performing a periodic test after installation or by performing the
qualification test.
(4) Measure and post the travel height of the mobile unit in a location that is readily visible to the
vehicle operator.
(5) Comply with all requirements of the applicable Federal Motor Vehicle Safety Standards in effect
at the time of installation when installing a digger derrick on a chassis that is a highway vehicle.
(6) Certification as a manufacturer (alteration, intermediate or final) of a motor vehicle under the
Federal Motor Vehicle Safety Standards is required.
7.6 Quality Assurance. The installer shall have a documented quality assurance program that will ensure
compliance with this standard.
7.7 Welding. All welds made by the installer, whose failure could result in motion of the digger derrick, shall
meet the Structural Welding Code ANSI/AWS D1.1/D1.1M and ANSI/AWS D1.2/D1.2M. The installer shall
establish applicable welding quality assurance procedures for all welded joints and assemblies. If
nondestructive testing is designated, the particular method used shall be in accordance with ANSI/AWS
B1.10.
7. RESPONSIBILITIES OF DEALERS AND INSTALLERS B - 1
8. RESPONSIBILITIES OF OWNERS B - 2
9. RESPONSIBILITY OF USERS B - 5
10. RESPONSIBILITIES OF OPERATORS B - 6
11. RESPONSIBILITIES OF LESSORS OR LESSEES B - 9
12. RESPONSIBILITIES OF BROKERS B - 10
To Next Page
Loading...
Need help?
General
