DIGGER DERRICK
-XI
Digger Derrick Terex South Dakota, Inc. 463280 - 9/14
SAFETY
15. Contact of any portion of the Digger Derrick boom below the insulating section with an energized
component will energize the entire vehicle. Anyone contacting the vehicle and the ground will be a path
for electric current.
1. Only use hydraulic tools equipped with orange hoses marked NON-CONDUCTIVE both at the platform
and the ground tool connections. The hoses must be kept clean, dry, and inspected before use.
2. All accessories must be inspected, maintained and operated with the same care and safety rules that
apply to the Digger Derrick.
3. Tools selected for use with the Digger Derrick must be of the open center type and operate at 2250 PSI
(15.51 MPa) and flow input shall not exceed the maximum tool rating.
1. Never travel with personnel in the platform or at the control locations.
2. Never travel with the boom(s) raised.
3. Store boom(s) properly in the boom rest with all boom sections fully retracted. If fiberglass boom is not
fully retracted, the fiberglass may craze, shatter or eventually buckle.
4. Maintain boom rest for proper securement during travel. Repair as required.
5. Secure all tools and items stored on the vehicle while traveling to prevent objects falling on the roadway.
6. Follow proper load securement procedures for loads on vehicle and trailers.
7. Fully retract the outriggers, store the outrigger pads and wheel chocks.
8. Disengage the power take-off to prevent damage.
9. Follow the vehicle manufacturer's instructions for operating the vehicle.
10. Remove and store personnel platform for road travel.
11. All operators and passengers must at all times travel in seating positions designated by the vehicle
manufacturer. They shall use seat belts and/or all other personal restraint systems provided.
Drive Carefully!
ACCESSORIES
TRAVELING
To Next Page
Loading...
Need help?
General
