DIGGER DERRICK
-I
Digger Derrick Terex South Dakota, Inc. 463280 - 9/14
INTRODUCTION
INTRODUCTION
OWNERS, USERS AND OPERATORS
Thank you for choosing Terex South Dakota, Inc. equipment for your application. User safety is our number
one priority and this is best achieved by our joint efforts.
As equipment users and operators, you make a major contribution to safety if you:
1. Comply with OSHA, federal, state, ANSI, local and your company regulations.
2. Read, understand and follow the instructions in this manual and other manuals supplied with this
vehicle.
3. Only allow trained operators, directed by informed and knowledgeable supervision, to run the unit.
If there is anything in this manual that is not clear or you believe should be added, please send your
comments to:
Manager of Publications
Terex South Dakota, Inc.
500 Oakwood Road
Watertown, South Dakota 57201
You may also contact us by phone at: (605) 882-4000
This manual contains important information on the safe use of your Terex South Dakota, Inc. equipment.
Your failure to read, understand and follow all safety rules, warnings and instructions will unnecessarily
expose you and others to dangerous situations. For your safety and the safety of those around you, you
must operate your Terex South Dakota, Inc. equipment as instructed in this manual.
This manual shall be stored on the vehicle for access by the operator. The Operators manual is required to
be stored on the vehicle by ANSI and OSHA regulations.
PRODUCT IDENTIFICATION
The serial number is located on the ID plaque. It may be located on the turntable, pedestal or lower boom,
depending on options and features. The serial number of the vehicle (VIN) will be different than the serial
number for the Aerial Device. Please refer to the Aerial Device serial number when contacting Terex South
Dakota, Inc. for service and parts information. Refer to the ID plaque for capacity and dielectric information.
INTENDED USE
This machine is intended to be used to perform multiple operations. If equipped with material handling
features it may be used to lift material, including poles, only within its rated capacity. Units equipped with an
auger can be used for digging operations. Use of this product in any other way is prohibited and contrary to
its intended use.
This is the safety alert symbol. It is used in this manual to alert you to potential
personal injury hazards. Obey all safety messages that follow this symbol to avoid
possible injury or death.
Serial Number
To Next Page
Loading...
Need help?
General
