2.3 ANSI Safety Sign Location
The safety signs are located in/on the machine as indicated. (Descriptions of the
symbols are provided in section 2.2)
Key
1. Fall hazard
2. Crush hazard (lift arms)
3. Skin (oil) injection hazard
4. Fire hazard (read manual)
5. Burn hazard
6. Explosion / burn hazard (read operator’s manual)
7. Tie down location
8. Clean undercarriages notice
9. Crush hazard (run over)
10. Crush hazard (lift arm brace)
12
CRUSH HAZARD
Contact with moving machine can
result in death or serious injury.
Keep clear of moving machine.
2030-593
Crush Hazard
Death or serious injury can result
from contact with moving lift arm or
attachment.
Keep clear of lift arms and
attachments.
2030-592
Crush Hazard
Death or serious injury can result
from contact with moving lift arm or
attachment.
Install lift arm brace prior to servicing.
2030-594
Burn Hazard
Hot fluid under pressure can scald.
Allow the machine to cool thoroughly
before opening.
2030-595
Fall Hazard
Serious injury or death can result
from falling.
Use the provided access system when
entering or exiting the machine.
2030-597
Injection Hazard
Escaping fluid under pressure can
penetrate skin, causing serious injury.
• Relieve internal pressure before
disconnecting any line or fitting.
• Keep away from leaks or pinholes.
• Use cardboard to check for leaks.
Fluid injected into skin must be surgi-
cally removed within a few hours by a
doctor familiar with this type of injury
or gangrene will result.
2030-602
Fire Hazard
Flammable debris can collect near hot
components and lead to a fire.
Read Operator’s manual
Keep engine, exhaust and chassis
areas free of debris.
2030-599
Explosion/Burn Hazard
Will cause death, burns or
blindness due to ignition of
explosive gasses or contact
with corrosive acid.
• Keep all flames/sparks
away!
• No Smoking!
• Read and understand
all manuals prior to
operation.
2030-603
1
3
2
45
6
7
10
9
Inspect undercarriages daily for
accumulation of debris. If debris
is present, clean thoroughly with
a pressure washer. If debris is
allowed to build up, it can cause
premature component wear and
decrease machine performance.
2085-253
NOTICE
8
R160T / R190T US O&M
0404-490 2014-06
To Next Page
Loading...
Need help?
General
