19
Installing the Roll Bar
1. Lower roll bar onto frame, aligning mounting holes as
shown in Figure 14.
2. Secure roll bar to frame with 4 bolts (3/4 x 5-1/2 in.),
lock washers, and nuts (Fig. 14). Tighten securely.
1
Figure 14
1. Roll bar
Pushing the Traction Unit Off
of the Pallet
1. Reach in and rotate bypass valve on transmission
(Fig. 15) counterclockwise 1/2 to 1 turn. Opening the
valve opens an internal passage in the pump, thereby
bypassing transmission oil. Because fluid is bypassed,
the machine can be pushed without damaging the
transmission.
1
Figure 15
1. Bypass valve
2. Lift machine over shipping braces and push machine off
pallet.
3. Close bypass valve by rotating it clockwise until it is
securely seated. Do not exceed 5 to 8 ft.-lb. (7 to
11 N⋅m). Do not start engine when valve is open.
Activating and Charging the
Battery
Use only electrolyte (1.265 Specific Gravity) to fill battery
initially.
1. Remove the battery from the machine.
Important Do not add electrolyte while the battery is in
the machine. You could spill it, causing corrosion.
2. Clean the top of the battery and remove the vent caps
(Fig. 16).
1
Figure 16
1. Vent caps
3. Carefully fill each cell with electrolyte until the plates
are covered with about 1/4 inch (6 mm) of fluid.
1
Figure 17
1. Electrolyte
To Next Page
Loading...
Need help?
General
