Toro Hydroject 3000 User Manual

9
Depths and Nozzle Configurations
All nozzles are identified with numbers indicating the drill size of the orifice. The standard configuration is 11 nozzles
producing depths of 4 to 6 inches depending on turf conditions. Blocked nozzle locations are obtained by reversing the nozzle
check valve ball and spring. See nozzle size chart and illustrations below:
Important Use only nozzle configurations shown or damage to the machine may occur.
Nozzle Size and Approximate Depth Chart
Part No
Drill Size
Decimal Metric Size
Quantity of Nozzles
A
pp
rox.
Part No. Drill Size
Decimal
Size (inch)
Metric Size
(mm)
Open Blocked
Approx
.
Depth
86-8130 #56 0.0465 1.181 * * *
86-8131 #53 0.0595 1.511 11 0 4–6 in.
86-8133 #46 0.081 2.057 6 5 6–8 in.
* Use only with varied size configurations
Note: Aluminum Washer, Toro Part no. 80-6680, is required with any nozzle change.
Optional Staggered Size Nozzle Configuration
Part No
Drill Size
Decimal Metric Size
Quantity of Nozzles
A
pp
rox.
Part No. Drill Size
Decimal
Size (inch)
Metric Size
(mm)
Open Blocked**
Approx
.
Depth
86-8130 #56 0.0465 1.181 6 and 0** 3–4 in.
86-8133 #46 0.081 2.057 5 0** 6–8 in.
** Additional nozzles may be blocked to compensate for pump wear.
Note: Aluminum Washer, Toro Part no. 80-6680, is required with any nozzle change.
Closed (Blocked) Nozzle
Open Nozzle
Spring
Spring
Check Valve Ball
Check Valve Ball

Toro Hydroject 3000 Specifications

General

Brand	Toro
Model	Hydroject 3000
Category	Tiller
Language	English