53
Setting up your TV
Viewing the system status
Viewing the system status
1 Press the MENU button and open the Setup menu.
2 Highlight Installation, and then press the ENTER button.
A new set of Installation menu icons appears.
3 Open the System Status menu, highlight System
Information, and then press the ENTER button.
4 Press the ( / arrow) buttons to scroll through the menu bar
to select Factory Defaults or Support Information.
The related information appears.
To close the screen and return to the Installation menu:
❖ Highlight Done in the Support Information screen, and then
press the ENTER button.
To return to normal viewing, press the EXIT button.
Resetting Factory Defaults
To reset all settings and channels to their factory default values:
1 Press the MENU button and open the Setup menu.
2 Highlight Installation, and then press the ENTER button.
A new set of Installation menu icons appears.
3 Open the System Status menu, highlight System
Information, and then press the ENTER button.
4 Press the ( / arrow) buttons to scroll through the menu bar
to select Factory Defaults.
5 Highlight Ye s, and then press the ENTER button.
6 If a PIN code has been set, enter your PIN code.
7 Press the ( / arrow) buttons to select Done, and then press
the ENTER button.
A warning message appears.
8 Select Ye s, and then press the ENTER button.
The TV turns off automatically after a few seconds.
9 After the TV turns off, unplug the TV power cord and then
plug it in again to complete the reset process.
To cancel the reset process, select No, and press the ENTER button
in step 5 above.
To Next Page
Loading...
Need help?
General