Toshiba eS305CS User Manual

Action Yes No
Step 3
a Remove held jobs stored in the printer memory.
b Resend the print job.
Did the job print?
The problem is solved. Go to step 4.
Step 4
a Disable the Page Protect feature.
From the printer control panel, navigate to:
Settings > General Settings > Print Recovery > Page Protect > Off
b Resend the print job.
Did the job print?
The problem is solved. Go to step 5.
Step 5
Install additional printer memory, and then resend the print job.
Did the job print?
The problem is solved. Contact
customer
support.
Repeating defects appear on prints
Action Yes No
a Check if the distance between the defects is equal to one of the
following:
• 25.1 mm (0.98 in.)
• 29.8 mm (1.17 in.)
• 43.9 mm (1.72 in.)
• 45.5 mm (1.79 in.)
• 94.2 mm (3.70 in.)
b If the distance between the defects equals 25.1 mm (0.98 in.), 29.8 mm
(1.17 in.), or 94.2 mm (3.70 in.), then replace the photoconductor unit.
c If the distance between the defects equals 43.9 mm (1.72 in.) or
45.5 mm (1.79 in.), then replace the developer unit.
Do the repeating defects still appear?
1 Check if the
distance between
the defects is
equal to one of the
following:
• 37.7 mm
(1.48 in.)
• 78.5 mm
(3.09 in.)
• 95 mm
(3.74 in.)
2 Take note of the
distance, and then
contact
customer
support or your
service
representative.
The problem is solved.
Troubleshooting 178

Toshiba eS305CS Specifications

General

Brand	Toshiba
Model	eS305CS
Category	Printer
Language	English