EM -26
ENGINE MECHANICAL - Timing Belt
TIMING BELT
COMPONENTS
No.2 Timing Belt Cover
Camshaft Timing Pulley Timing Belt
RH Engine Mounting Bracket
(FF Vehicles!
Injection Pump Drive Pulley Tension
No.1 Idler Pulley Spring
No. 2 Idler
Pulley
Oil Pump
Drive Pulley
Fan Bracket
(FR Vehicles)
No. I Timing Belt Cover
Crankshaft Pulley
Timing Belt Guide
Crankshaft Tuning Pulley
REMOVAL OF TIMING BELT
1. REMOVE PS PUMP PULLEY AND DRIVE BELT
(FF Vehicles)
(al Push on the drive belt to hold the puney in place
and remove the pulley nut.
lb) Loosen the drive belt adjusting bolt
kl Remove the drive bell
(d) Remove the pulley and woodruff key.
2. REMOVE PS PUMP (FF Vehicles)
Remove the three bolts and PS pump .
ENGINE MECHANICAL - Timing Belt
EM-27
3. REMOVE DRIVE BELT
(a) Loosen the four fan pulley nuts. (FR Vehicles)
lbl Loosen the alternator pivot adjusting lock bolt and
adjusting nut or boll
(c) Swing the alternato r toward the engine and remove
the drive beh.
4. REMOVE FLUID COUPLING AND FAN PULLEY
(FR Vehicles)
5. REMOVE PS PUMP DRIVE BELT (FR Vehicles)
6. REMOVE NO. 2 TIMING BELT COVER
Remove the three clips, five bolts and the No. 2 timing belt
cover with the gasket.
7. REMOVE FOUR GLOW PLUGS
(See step 10 on page EM-49)
8.
NOTE: It is necessary to remove the glow plugs so that
the crankshaf t will tum smoothly and enable the belt to be
adjusted properly .
SET NO. 1 CYLIND ER AT TDC/COMPRESSION
Align the line mark of the camshaft timing pulley with the
top end of the cylinder head by turning the crankshaft
pulley clockwise .
9. REMOVE CRANKSHAFT PULLEY
(al Install the SST to the crankshaft pulley .
SST 09213-14010
(bl Using SST to hold the crankshaft pulley, remove the
pulley bolt.
SST 0 9330 -0002 1
(cl Using SST. remove the crankshaft pulley .
SST 09213_-31021
To Next Page
Loading...
Need help?
General
