Toyota HILUX 2008 User Manual

101002
MILEAGE/FUEL CONSUMPTION DISPLAY
Only the display for fuel consumption
rate (L/100 km) and mileage (km/I) may
be interchanged using the following
procedure:
1. Get access to the average fuel con-
sumption or instantaneous fuel con-
sumption display.
2. Hold down the "INFO." button until the
unit flashes.
3. Push
the "RESET" button to change
the unit.
4. Push the "INFO." button.
150
AVERAGE VEHICLE SPEED
("AVG. km/h")
Average vehicle speed is calculated and
displayed based on total driving dis-
tance and total driving time with the
engine running.
To reset the calculations, push and hold
the "RESET" button for more than sec-
ond.
DRIVING TIME ("E/T")
The elapsed time after the ignition is
turned on is displayed.
When the ignition is turned on, driving
time is counted from 0:00. Up to 19:59
(19 hours, 59 minutes) can be displayed.
When the driving
time exceeds 19:59, the
counter returns to 0:00.
To reset the display, push and hold the
"RESET" button for
more than 1 second.
DRIVING RANGE
("RANGE km")
The distance the vehicle can travel with
the remaining fuel is calculated and
displayed based on the quantity of re-
maining fuel and past fuel consumption.
The driving range display indicates the
approximate distance that you can drive
until the fuel
gauge reaches "E". It is
different from the actual distance traveled.
Every time you refuel the vehicle, the cal-
culation is reset.
The actual driving range
varies with driv-
ing habits and road conditions.
If fuel con-
sumption is good,
the driving range will be
longer than indicated.
If fuel consumption
is poor,
the driving range will be shorter
than indicated.
If the low fuel level warning light comes
on, refuel the
vehicle even if the display
indicates that the vehicle can be driven
further.
Not For Reproduction

Toyota HILUX 2008 Specifications

General

Brand	Toyota
Model	HILUX 2008
Category	Automobile
Language	English