Toyota HILUX 2008 User Manual

CHILD RESTRAINT ANCHORAGE
1. Remove the plug immediately behind
where
the child restraint will be posi-
tioned on the rear seat.
62
2. Install a 5/16" 18 UNC x 30 mm (1.2
in.) bolt
through the lock washer and
anchor fitting. Tighten the bolt securely
with the
anchor fitting facing the front
of the vehicle as shown.
Use a 5 mm (0.2 in.) or 10 mm (0.4
in.)
spacer or both ones if necessary.
Uppo, ""hom90 "'~
~ ~
Front of vehicle ~
Anchor fitting
113139
ATTACHMENT OF THE ATTACHING CLIP
Attach the child restraint attaching clip to
the child restraint anchor fitting. Make
sure the clip is securely attached and
tighten the
upper anchorage strap.
&CAUTlON
o Make sure the seat belt is securely
locked, and check that the child re-
straint system is secure by pushing
and pulling it in
different directions .
•
Follow all the installation instruc-
tions provided by its manufacturer.
Not For Reproduction

Toyota HILUX 2008 Specifications

General

Brand	Toyota
Model	HILUX 2008
Category	Automobile
Language	English