Name: TP-Link ARCHER C1200
Brand: TP-Link
Rating: 4 (1 reviews)

To Next Page

To Previous Page

Chapter 4

Set Up Internet Connection

Note:

It may take 1-2 minutes to make the settings valid.

Tips:

• If your internet connection type is BigPond Cable, please go to Advanced > Network > Internet to set your router.

• If you use Dynamic IP and PPPoE and you are provided with any other parameters that are not required on the page,

please go to Advanced > Network > Internet to complete the configuration.

• If you still cannot access the internet, refer to the FAQ section for further instructions.

4. 3. Set Up an IPv6 Internet Connection

Your ISP provides information about one of the following IPv6 internet connection types:

PPPoE, Dynamic IP(SLAAC/DHCPv6), Static IP, 6to4 tunnel, Pass-Through (Bridge).

1. Visit

http://tplinkwifi.net, and log in with your TP-Link ID or the password you set for

the router.

2. Go to

Advanced > IPv6.

3. Enable IPv6 and select the internet connection type provided by your ISP.

Tips:

If you do not know what your internet connection type is, contact your ISP or judge according to the already known

information provided by your ISP.

4. Fill in information as required by different connection types. Red blanks must be filled

in.

1 )

Static IP: Fill in blanks and click Save.

Other manuals for TP-Link ARCHER C1200

Questions and Answers:

Need help?

Do you have a question about the TP-Link ARCHER C1200 and is the answer not in the manual?

General