TP-Link TL-WA500G User Manual

TL-WA500G 54M Wireless Access Point User Guide
1.3.2 The Rear Panel
Figure 1-2 TL-WA500G rear panel
Viewed from left to right, the following parts are located on the rear panel of TL-WA500G.
Wireless antenna：The external antenna is used to transmit and receive wireless data.
RESET: The Reset button is used to restore the AP’s factory default settings. There are two ways
to reset the Access Point’s factory defaults:
z Method one: With the Router powered on, use a pin to press and hold the Reset button
(about 5 seconds) until the System LED becomes quick-flash from slow-flash. And then
release the button and wait the router to reboot to its factory default settings.
z Method two: Restore the default settings from “System Tools > Factory Defaults” of the
Modem's Web-based management page.
) Note:
Ensure the AP is powered on before it restarts completely.
LAN: One LAN 10/100Mbps RJ45 port connects to a network device, such as a switch or a router.
POWER: The power port connects to the power adapter provided with the TL-WA500G 54M
Wireless Access Point.
6

TP-Link TL-WA500G Specifications

General

2.4 GHz	Yes
Modulation	DBPSK, DSSS, OFDM, QPSK
Frequency band	2.4 - 2.4835 GHz
Cabling technology	10/100Base-T(X)
Maximum data transfer rate	54 Mbit/s
Wireless technology	802.11b/g
Compliance industry standards	IEEE 802.11g, IEEE 802.11b
Non-operating relative humidity (non-condensing)	10 - 90 %
Ethernet LAN (RJ-45) ports	1
Storage temperature (T-T)	-40 - 70 °C
Operating temperature (T-T)	0 - 40 °C

Weight and Dimensions

Dimensions (WxDxH)	150 x 100 x 28 mm