Truma DLE60C Operating And Installation Instructions

21
Interrupting decalcification
Decalcification is indicated through slow
flashing (1s on, 1s off) of the status LED 3
(Fig. 9) on the control panel.
• Decalcification can be interrupted by switch-
ing the control panel to “Off”.
– Decalcification is interrupted after about 2 s.
– The status LED 3 (Fig. 9) on the control
panel flashes quickly.
• Irritation of skin and eyes in
case of contact with decalcification agent.
Wear protective gloves, eye protection and
face protection to avoid contact.
• First you must take out the water inlet filter
and remove any AquaGo decalcification tab-
lets that it may contain.
– To take out the water inlet filter, see
“Draining the water and cleaning the wa-
ter inlet filter” on page15.
– Dispose of AquaGo decalcification tablets
in accordance with local laws and regula-
tions.
• Before you use the water system again, you
must rinse it (see step f) “Rinsing the water
system” on page19) and fill it with water
(see step g) “Filling the water system” on
page20).
Accessories
Electric antifreeze kit *
Truma offers an electric antifreeze kit (part no.
77400-01) that keeps the appliance frost-free
to -4 °F (-20 °C) while you are driving or if there
is no gas supply. To operate the kit, you need
a 12VDC (120W) power supply from the ve-
hicle’s on-board system. Ask your dealer.
* For AquaGo comfort / AquaGo comfort plus.
AquaGo decalcification tablets
Truma offers decalcification tablets (part no.
77300-01) to decalcify AquaGo comfort /
AquaGo comfort plus.
Truma rear installation gas connection kit
Truma offers a rear installation gas connection
kit (part no. 77000-37500) if installation from the
back of the appliance is required.
AquaGo comfort upgrade kit
Truma offers a kit (part. no. 77000-00005) to up-
grade from AquaGo basic to AquaGo comfort.

Truma DLE60C Specifications

General

Brand	Truma
Model	DLE60C
Category	Water Heater
Language	English