To Next Page

To Previous Page

– Install the side gas pipe grommet with

the control panel cable in the side hole.

Gas pipe

grommet

(side)

Control panel cable

Fig. 33

Checking for gas leaks

Risk of death and personal injury through

fire and/or explosion!

• DO NOT use matches, candles or other

sources of ignition when checking for gas

leaks.

• After the gas supply is connected, check

for gas leaks at all gas connections. Use a

gas leak detection liquid.

1. Turn OFF the electrical power supply

2. Damage to the appliance from

test pressure higher than 60 in. wc

(150mbar). Ensure that the test pres-

sure is lower than 60 in. wc (150 mbar).

3. Turn on the gas.

4. Check the appliance and all gas connections

for gas leaks with leak detection liquid.

– Bubbles indicate a gas leak that must be

repaired.

5. Repair gas leaks as needed.

6. Repeat check for gas leaks at all gas connec-

tions.

Functional check

1. Start the appliance (refer to “Starting the ap-

pliance” on page9).

2. Check the appliance for proper functionality.

If faults occur during operation of the

appliance, refer to “Troubleshooting” on

page22.

3. Provide operating and installation instruc-

tions to the vehicle owner.

The appliance is now ready for normal operation.

Truma DLE60C Operating And Installation Instructions

Other manuals for Truma DLE60C