Front Matter Sageon Micro Power Module Manual
PM990-4207-00, Rev 6
vi
7. APPENDIX A – SETTING UP NETWORK INTERFACES .......................................................................... 7-1
7.1 PROGRAMMING IP ADDRESSES USING DEVICE INSTALLER SOFTWARE .................................. 7-1
7.1.1 Preparations for local address set up ........................................................................................................ 7-1
7.1.2 Local IP address set up procedure ........................................................................................................... 7-1
7.1.3 Preparations for gateway address set up .................................................................................................. 7-1
7.1.4 Gateway IP address set up procedure ...................................................................................................... 7-1
7.2 PROGRAMMING IP ADDRESSES USING ARP AND TELNET ACCESS ............................................ 7-2
7.2.1 Preparations for local address set up ........................................................................................................ 7-2
7.2.2 Local IP address set up procedure ........................................................................................................... 7-2
7.2.3 Configuring the Unit ................................................................................................................................ 7-3
7.2.3.1 Using a Telnet Connection ............................................................................................................. 7-3
7.2.4 Server Configuration (Network Configuration) ....................................................................................... 7-4
8. SPECIFICATIONS ............................................................................................................................................. 8-1
FIGURES
Figure 2.1 System blocks (2RU Series) .................................................................................................................... 2-1
Figure 2.2 System blocks (3RU Series) .................................................................................................................... 2-1
Figure 2.3 System blocks (4RU Series) .................................................................................................................... 2-2
Figure 2.4 System blocks (5RU Series) .................................................................................................................... 2-2
Figure 2.5 System blocks (6RU Series) .................................................................................................................... 2-3
Figure 2.6 System blocks(7RU Series) ..................................................................................................................... 2-3
Figure 2.7 Rear view of connections ......................................................................................................................... 2-4
Figure 2.8 Connections on Controller backplane ...................................................................................................... 2-5
Figure 2.9 Alarm relay board connections ................................................................................................................ 2-5
Figure 3.1 Mount points for securing Power shelf in a rack ..................................................................................... 3-1
Figure 3.2 Opening top rear cover to access wiring ................................................................................................. 3-2
Figure 3.3 Typical Powershelf internal schematic diagram ...................................................................................... 3-3
F
igure 3.4 AC Feed Terminations ............................................................................................................................. 3-4
Figure 3.5 Single Phase-Individual Protected External Feeds ................................................................................... 3-5
Figure 3.6 Three Phase Y-Individual Protected External Feeds ................................................................................ 3-6
Figure 3.7 Three Phase Delta-Individual Protected External Feeds .......................................................................... 3-6
Figure 3.8 Surge Protection ....................................................................................................................................... 3-7
Figure 3.9 Bulk Load Connections ............................................................................................................................ 3-8
Figure 3.10 Circuit Breaker Aux. Contacts .............................................................................................................. 3-8
Figure 3.11 Battery Connections ............................................................................................................................... 3-9
Figure 3.12 Alarm relay connections (right) and remote communications module location (left) ......................... 3-10
Figure 3.13 RS485 pin assignments ....................................................................................................................... 3-11
Figure 3.14 Battery String Kit Installation .............................................................................................................. 3-14
Figure 3.15 Load Connection Kit Installation ......................................................................................................... 3-14
Figure 6.1 Removing Rectifier Module or Controller ............................................................................................... 6-4
To Next Page
Loading...
Need help?
Input Power