27
Maintenance schedule
Every 50 operating hours
● Fuel pre-filter. Check and drain .................................................................... page 52
● Batteries. Check charge condition ................................................................ page 57
● Reverse gear (Twin Disc). Lubrication
1)
....................................................... page 63
● Disengageable clutch. Lubrication
2)
............................................................. page 65
1)
Applies to output shaft seal.
2)
Applies to release bearing when operated more than 15 times a day.
Otherwise, every 500 operating hours.
Every 200 operating hours / at least every 12 months
● Crankcase ventilation. Change filter ............................................................. page 30
● Reverse gear (ZF/MPM). Cleaning oil strainer ............................................. page 61
Every 500 operating hours / at least every 12 months
● Drive belts. Inspection .................................................................................. page 30
● Air filter (TAMD103). Cleaning ...................................................................... page 31
● Coolant (Anti-corrosion mixture). Topping up
1)
............................................. page 38
● Charge air cooler. Check drainage ............................................................... page 47
● Batteries. Checking electrolyte level ............................................................. page 56
● Disengageable clutch. Lubrication
2)
............................................................. page 65
1)
This applies only if the cooling system is filled with an anti-corrosion mixture.
2)
Applies to release bearing.
Every 1000 operating hours / at least every 12 months
Valve clearances. Check/Adjust ........................................................... not illustrated
● Freshwater filter. Change
1)
.......................................................................... page 40
● Impeller (Seawater pump). Check/Change .................................................. page 45
● Zinc anodes. Check/Change
2)
..................................................................... page 45
● Seawater filter. Check/clean.
3)
...................................................................... page 46
● Charge air cooler. Cleaning .......................................................................... page 47
● Heat exchanger. Cleaning ............................................................................ page 48
● Oil cooler (Engine/Reverse gear). Cleaning.................................................. page 49
● Fuel filters. Change ...................................................................................... page 51
● Fuel system. Bleeding. ................................................................................. page 51
1)
Not to be done in connection with changing the coolant.
2)
Interval depends on local conditions
3)
Cleaning may be required more often if operating in severely
polluted water. This can be determined by experience after a
period of operation.