31
Maintenance: Engine, general
Air filter indicator. Checks
TAMD122A/P is equipped with a pressure drop indi-
cator (1). When the indicator is completely in the red
zone when the engine is stationary, the air filter must
be changed earlier than recommended. The indicator
can be reset by pressing the button.
TAMD122A
1. Undo the clips holding the filters.
2. Remove the filters.
3. Fit new filters and tighten the clips.
4. Reset the pressure drop indicator (1).
TAMD122P
1. Undo the wing nut.
2. Pull off the cover and filter (the filter normally fas-
tens to the cover).
3. Fit the new filter, fasten the cover and tighten the
wing nut.
4. Reset the pressure drop indicator (1).
Air filter. Change/Clean
TAMD103A
1. Undo the wing nut.
2. Pull off the cover.
IMPORTANT! Change the air filter insert if it
is damaged.
3. Take out the air filter insert.
4. Wash the filter insert in clean diesel oil. Squeeze
out the diesel oil.
5. Dip the filter insert into clean engine oil. Squeeze
out the engine oil.
6. Refit the filter insert. Fit the cover
1
1
To Next Page
Loading...
Need help?
General
