Operation RD 27
46 wc_tx000814gb.fm
4.24 Starting the Engine
Procedure
Follow the procedure below to start the engine.
1. Sit down in the operator’s seat and fasten the seat belt.
2. Move the forward/reverse (f) lever to the NEUTRAL position.
3. Push the parking brake push button (h) to engage the parking brake.
4. Move the throttle to the LOW position (1).
5. Turn the starting key to POSITION 1. Check for power to the control panel. The
oil pressure and alternator lights should illuminate.
6. Turn the starting key to POSITION 2 and hold it there for approximately 15
seconds to supply power to the glow plugs. In warmer weather the time period
may be reduced.
7. Immediately after powering the glow plugs, turn the key to POSITION 3 to crank
the engine. When the engine fires, release the starting key to avoid straining the
starter motor.
NOTICE: Do not crank the engine for periods longer than 30 seconds. Turn the
key back to OFF and wait 15 seconds before cranking the engine again.
DANGER
Asphyxiation hazard. Engine exhaust contains carbon monoxide which CAN KILL
YOU IN MINUTES. This is a poison that you cannot see or smell.
f Do not start the engine in enclosed spaces.
To Next Page
Loading...
Need help?
General
