WEIHONG Lambda 5S Series User Manual

上海维宏电子科技股份有限公司
Weihong Electronic Technology Co., Ltd.
- 14 - Specialized, Concentrated, Focused
2.2.2 Glass Cutting
Glass cutting software includes five kinds of configuration—XYA config, XYZA config, X1YAX2
config, XYA no edge config and XYZA no edge config. See this section for wiring diagrams of Lambda
4S controller according to the five configurations respectively.
 XYA Config
Open the cover and connect extended
terminal board EX27A3
Cycle Start
Cycle Stop
Pause
Manual Movement in +X
ESTOP
Manual Movement in -X
Manual Movement in +Y
Manual Movement in -Y
Manual Movement in +A
Manual Movement in -A
Oil Level Detection Alarm
Tool Bit Over-travel
X Axis REF. Point
+X Limit
-X Limit
Y Axis REF. Point
+Y Limit
-Y Limit
+A Limit
-A Limit
A Axis REF. Point
+24V Power
Active High/Low
To connect
PM85A/95A
To connect
X-axis driver
To connect
Y-axis driver
To connect
A-axis driver
To connect
MPG
Kerosene
Analog Enable
Lube Oil
Green
Red
Yellow
Suction
Common
Common
Common
Common
Common
Analog Output
Fig. 2-5 Connection according to XYA configuration

WEIHONG Lambda 5S Series Specifications

General

Brand	WEIHONG
Model	Lambda 5S Series
Category	Controller
Language	English