WEIHONG Lambda 5S Series User Manual

上海维宏电子科技股份有限公司
Weihong Electronic Technology Co., Ltd.
- 32 - Specialized, Concentrated, Focused
2.2.4 Three Axes Laser Cutting
When used together with three axes laser cutting software, Lambda 5S controller should be wired
according to Fig. 2-23 in dual Y configuration.
Open the cover, and connect extended
terminal board EX30A3
Cycle Start
Cycle Pause
Breakpoint Resume
Cutting Head Collision Alarm
Cutting Head Alarm
Z-axis Brake
+X Limit
-X Limit
+Y Limit
-Y Limit
+Z Limit
-Z Limit
X Axis REF. Point
Y1 Axis REF. Point
ESTOP
Z Axis REF. Point
General Input
Y2 Axis REF. Point
+24V Power
Active High/Low
Z-axis Brake
Red
Green
Yellow
Laser Gate
Blow (Air)
Follow
Z-up
Common
Common
Common
Common
Common
Analog Output
To connect
PM85A/95A
To connect
X-axis driver
To connect
Y1-axis driver
To connect
Y2-axis driver
To connect
Z- axis driver
To connect
MPG
General Input
General Input
General Input
Manual Movement in -Y
Manual Movement in +Y
Manual Movement in -X
Manual Movement in +X
Set Workpiece Origin
Follow In-position
Cycle Stop
Fig. 2-23 Connection according to doubleY configuration
CAUTION
The software consists of singleY configuration and doubleY configuration. The wiring of singleY configuration is
the same as that of doubleY configuration, except for two differences:
1) In singleY configuration, only X, Y and Z axes should be connected to the first three axes driver interfaces.
2) In singleY configuration, X08 is defined as Y-axis REF. point and X09 general input.

WEIHONG Lambda 5S Series Specifications

General

Brand	WEIHONG
Model	Lambda 5S Series
Category	Controller
Language	English