Service manual Troubleshooting and repair 43
• The Debug Log lists the most recent warning conditions that have occurred, up to
the maximum log size.
When the Event and Debug Logs reach maximum size, new data overwrites the oldest.
• The Calibration & User Log provides the following categories of information:
• calibration
• user-configuration
• run-time and cycle count
• software versions of all modules
To view the log files
1. Click View Logs to access the logs.
2. Under Display, choose the desired log to load and view in the window.
To save the log files
1. Under Display, choose the desired log to save.
2. Click Save.
3. Navigate to the folder where the file will be saved.
4. Name the file.
5. Click Save.
To print the log files
1. Under Display, choose the desired log to print.
2. Click Print.
3. Select the printer and the print parameters.
4. Click Print.
Note
Large log files can take several minutes to load.
Note
The item counter, located on the right side below the radio buttons, sometimes
stops counting until all items have been retrieved from the monitor.
Note
Screen images shown are samples only. Actual screens vary with each release.
To Next Page
Loading...
Need help?
General
