PREPARING FOR FIERY EXP4110 SETUP
21
About Setup
Setup configures the Fiery EXP4110 to communicate with other devices and to manage print
jobs. Perform Setup the first time you turn on the Fiery EXP4110 after new system software
is loaded, or any time Server software is reinstalled. An initial Setup using default settings is
adequate to allow users to print to the Fiery EXP4110 and use the WebTools. When your
network or user printing environment changes, change the options accordingly.
NOTE: You cannot access Setup functions from Command WorkStation, Macintosh Edition.
Setup from the Control Panel
The first time you perform Setup, you must use the Control Panel. Configure, at a minimum,
Server Setup, Network Setup, and Printer Setup, in that sequence. After the initial Setup, you
can change Setup options from the Control Panel (page 23) or a Windows computer
(page 59). Most Setup options can be set using either of these methods.
If you do not configure the remaining Setup menus, the Fiery EXP4110 uses default settings.
You must choose settings appropriate for the printing environment at your site.
Setup from a network computer
Local Setup
Local Setup refers to setting up the Fiery EXP4110 from the Fiery Advanced Controller
Interface using Command WorkStation, Windows Edition.
Remote Setup
Remote Setup is the Setup method from a computer on the network using either the
Configure WebTool or Command WorkStation, Windows Edition.
To Next Page
Loading...
Need help?
General