SETTING UP THE FIERY EXP4110 FROM A NETWORK COMPUTER
65
NOTE: Confirm the subnet mask setting with your network administrator before proceeding.
In some cases, the required setting may be different from those listed.
If your TCP/IP network has a gateway and users outside the gateway plan to print to the
Fiery EXP4110 using TCP/IP, enter the gateway address.
NOTE: The Fiery EXP4110 stores assigned IP addresses, even if you later disable TCP/IP. If
you must assign the Fiery EXP4110 IP address to another device, first set the Fiery EXP4110
address to a null address.
DNS
You can enable DNS Setup to allow the Fiery EXP4110 to resolve a name to an IP address.
Security
IP Filtering Setup allows you to restrict unauthorized connections to the Fiery EXP4110. You
can permit access to only users whose IP addresses are within a defined range of IP addresses.
Commands or jobs sent from unauthorized IP addresses are ignored by the Fiery EXP4110.
Port Blocking Setup allows you to restrict unauthorized connections to the Fiery EXP4110 by
authorizing network activity only to certain ports. Commands or jobs sent from unauthorized
ports are ignored by the Fiery EXP4110.
Services
You can configure the following network services:
•NetWare Printing (PServer), including NDS and Bindery services
• LPD Printing (TCP/IP)
•Windows Print Sharing (SMB)
• SNMP Setup
•Web Services Support (support for WebTools)
• IPP Printing
•Port 9100
• E-mail Service
• FTP Service
To Next Page
Loading...
Need help?
General