September 2001 88XX Series Folder Operator Manual 36
Suspending the Print Queue
When the system is printing and folding a job, it is possible to suspend
the print queue as follows:
− The folder control panel shows the program in use (for example
185 [ p.01 ] ).
− Press the “Pause” key on the Alphanumeric Control Panel or the
“Enter” key on the Numeric Control Panel.
− The displays show “PAUSE” [ paus ], and the print queue stops.
− Pressing the same key again, the print queue will restart.
The keys “Pause” and “Enter” mentioned above, suspend
the queue only if the system is working and the display
shows the program selected. When the system is in “Idle”
status, these keys have their normal function which is to set the system
in Pause Mode in order to enter the Operator menu.
It could be useful to suspend the queue for many reasons: if a job
consisting of a lot of prints is wrong, suspending the job allows the
operator to delete the entire queue using the ACT.
To do this, select the “Printer Queue” tab in ACT. Select the second
toolbar button to update the print que status. Select (highlight) all of
the listed files. Select the Delete toolbar button to remove them from
the print queue.
To Next Page
Loading...
Need help?
General
