Selecting a Location for the Printer
• Leave enough room to open trays, covers, and doors and to install hardware options.
• Set up the printer near an electrical outlet.
CCAAUUTTIIOONN——PPOOTTEENNTTIIAALL IINNJJUURRYY:: To avoid the risk of fire or electrical shock, connect the power
cord to an appropriately rated and properly grounded electrical outlet that is near the product and
easily accessible.
CCAAUUTTIIOONN——SSHHOOCCKK HHAAZZAARRDD:: To avoid the risk of electrical shock, do not place or use this
product near water or wet locations.
• Make sure that airflow in the room meets the latest revision of the ASHRAE 62 standard or the CEN Technical
Committee 156 standard.
• Provide a flat, sturdy, and stable surface.
• Keep the printer:
– Clean, dry, and free of dust
– Away from stray staples and paper clips
– Away from the direct airflow of air conditioners, heaters, or ventilators
– Free from direct sunlight and humidity extremes
• Observe the temperature range.
Operating temperature: 10–32.2° C (50–90° F)
• Allow the following recommended amount of space around the printer for proper ventilation:
11 Top 101 mm (4 in.)
22 Rear 102 mm (4 in.)
33 Right side 76 mm (3 in.)
30
Xerox
®
C230 Color Printer User Guide
Set up, install, and configure
To Next Page
Loading...
Need help?
General